Product ID:6-85, SPEEDHIDE LATEX FLAT MIDTONE BASE
MSDS Date:05/16/1986
FSC:8010
NIIN:00N034172
MSDS Number: BPTTC

PPG INDUSTRIES INC

260 KAPPA DR
PITTSBURGH, PA 15238
US

Emergency Phone: 304-843-1300

Info Phone: 412-963-5822

Cage: 47695

PPG INDUSTRIES INC

PITTSBURGH, PA 15272 US

Telephone: 1-800-245-2974 (CAL HYPO)

Cage: 47695

CLAY (KAOLIN); (ALUMINUM SILICATE)

CAS: 1332-58-7

RTECS: GF1670500

Fraction By Weight: 5%

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 2 MG/M3 TDUST; 9293

WATER; (DEIONIZED WATER)

CAS: 7732-18-5

RTECS: ZC0110000

Fraction By Weight: 40%

PROPIONIC ACID, 2-METHYL-, MONOESTER

CAS: 25265-77-4

RTECS: UF6000000

Fraction By Weight: 1-2%

WATER

CAS: 7732-18-5

RTECS: ZC0110000

Fraction By Weight: 10 - 15%

FILM FORMERS, RESINS, AND ADDITIVES (PROPRIETARY)

Fraction By Weight: 5%

LIMITS, THE LEL BELOW STATED LIMIT AND TO REMOVE

RTECS: 9999999ZZ

ON SURFACES COATED WITH THIS PRODUCT.

RTECS: 9999999ZZ

TITANIUM OXIDE; (TITANIUM DIOXIDE)

CAS: 13463-67-7

RTECS: XR2275000

Fraction By Weight: 10%

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST; 9293

CLAY (KAOLIN); (ALUMINUM SILICATE)

CAS: 1332-58-7

RTECS: GF1670500

Fraction By Weight: 1-2%

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 2 MG/M3 TDUST; 9293

CALCIUM CARBONATE

CAS: 471-34-1

RTECS: FF9335000

Fraction By Weight: 20-25%

OSHA PEL 15MG/M3 TDUST;5RDUST

ACGIH TLV: 10MG/M3 TDUST

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INGEST: MAY BE HARMFUL IF SWALLOWED.
EYE: CAUSES IRRITATION. SKIN: MAY CAUSE MODERATE SKIN IRRITATION.
INHAL: VAPOR AND SPRAY MIST MAY BE HARMFUL IF INHALED. CHRONIC:
AVOID LONG-TERM AND REPEATED CONT ACT.
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:REDNESS, ITCHING, BURNING SENSATIONS AND VISUAL
DISTURBANCES MAY BE INDICATIONS THAT EXCESSIVE EYE CONTACT HAS
OCCURED. DRYNESS, ITCHING, CRACKING, BURNING, REDNESS, AND SWELLING
ARE CONDITIONS ASSOCI ATED WITH EXCESSIVE SKIN CONTACT.
Medical Cond Aggravated by Exposure:NOT APPLICABLE.

First Aid:INGEST:DO NOT INDUCE VOMIT. EYE:FLUSH IMMED W/PLENTY OF WATER
FOR @ LST 15 MIN. SKIN:FLUSH IMMED W/PLENTY OF WATER FOLLOWED BY
WASHING W/SOAP & WATER. INHAL:REMOVE TO FRESH AIR. APPLY ARTF RESP
& OTHE R SUPPORTIVE MEASURES AS REQD. OTHER:IFANY OF THE FOLLOWING
OCCUR DURING/FOLLOWING USE OF PROD, CONT POISON CONTROL CNTR, EMER
ROOM/MD IMMED; HAVE MATL SAFETY DATA SHEET INFO AVAILABLE. (SUPP
DATA)

Flash Point Method:PMCC
Flash Point:299F,148C
Extinguishing Media:USE NFPA CLASS B EXTING (CO*2/DRY CHEM/UNIVERSAL AQ
FILM FORMING FOAM) DESIGNED TO EXTING NFPA CLASS IIIB (SUPP DATA)
Fire Fighting Procedures:WEAR NIOSH/MSHA APPRVD SCBA & FULL PROT EQUIP
. WATER SPRAY MAY BE INEFTIVE. WATER SPRAY MAY BE USED TO COOL CLSD
CNTNRS TO PVNT PRESS BUILD-UP(SUPP DATA)
Unusual Fire/Explosion Hazard:CLOSED CONTAINERS MAY EXPLODE OR BURST
(DUE TO THE BUILD-UP OF STEAM PRESSURE) WHEN EXPOSED TO EXTREME
HEAT.

Spill Release Procedures:PROVIDE MAXIMUM VENT. ONLY PERS EQUIPPED
W/PROPER NIOSH/MSHA APPRVD RESP & SKIN & EYE PROT SHLD BE PERMITTED
IN AREA. REMOVE ALL SOURCES OF IGNIT. TAKE UP SPILLED MATL
W/SAWDUST, VERMICULITE/OTHER ABS ORBENT MATL & PLACE INTO
CONTAINERS FORDISPOSAL.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:DO NOT STORE > 120F. STORE LG QTYS IN
BUILDINGS DESIGNED AND PROTECTED FOR STORAGE OF NFPA CLASS IIIB
COMBUSTIBLE LIQUIDS. PROT FROM FREEZING.
Other Precautions:IF MATL IS PART OF MULTIPLE COMPONENT COATING SYSTEM,
READ MSDS FOR OTHER COMPONENT(S) BEFORE BLENDING AS RSLTG MIX MAY
HAVE HAZ OF ALL OF ITS PARTS. ALL CHEMICAL SUBTANCES IN PROD COMPLY
W/ALL APPLIC RULES & ORDERS (SUPP DATA)

Respiratory Protection:WHERE VENTILATION IS INADEQUATE, USE A SUITABLE
NIOSH/MSHA APPROVED RESPIRATOR.
Ventilation:PROVIDE GEN DILUTION/LOC EXHST VENT IN VOL & PATTERN TO
KEEP CONC OF INGS LISTED < LOWEST SUGGESTED EXPOS (ING 9)
Protective Gloves:NITRILE, NEOPRENE/LATEX RUBBER GLOVES.
Eye Protection:CHEMICAL WORKERS GOGGLES
Other Protective Equipment:WEAR PROTECTIVE CLOTHING CONSTRUCTED OF:
NITRILE, NEOPRENE OR LATEX RUBBER.
Work Hygienic Practices:CLEAN OR DISCARD CONTAMINATED CLOTHING & SHOES.
Supplemental Safety and Health
EXTING MEDIA: COMBUST LIQ FIRES. FIRE FIGHT PROC: & POSS
AUTOIGNIT/EXPLO WHEN EXPOSED TO EXTREME HEAT. IF WATER IS USED, FOG
NOZ ARE PREF. FIRST AID PROC: INGEST, EXCESSIVE EXPOS TO CORR MATL,
PERSIST ENT SKIN/EYE IRRIT/BRTHG DFCLTS. OTHER PREC: UNDER
ENVIRONMENTAL PROT AGENCY'S TOX SUBSTANCE CONTROL ACT.

HCC:N1
Boiling Pt:B.P. Text:>180F,>82C
Vapor Pres:17.4
Vapor Density:HVR/AIR
Spec Gravity:1.4
Evaporation Rate & Reference:34 (BUOAC=100)
Solubility in Water:50.9%
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:71.4

Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH STRONG ALKALIES, STRONG MINERAL ACIDS, OR STRONG
OXIDIZING AGENTS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:MAY PRDCE HAZ DECOMP PRODS WHEN
HEATED.WELDING BRAZING/FLAME-CUTTING ON SURF COATED W/PROD MAY
PRDCE FUMES INCLUDING CO.

Waste Disposal Methods:WASTE MATERIAL MUST BE DISPOSED OF I/A/W
FEDERAL, STATE AND LOCAL ENVIRONMENTAL CONTROL REGS. EMPTY
CONTAINERS SHOULD BE RECYCLED OR DISPOSED OF THROUGH AN APPROVED
WASTE MANAGEMENT FACILITY.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.